Guide fo E-Lift
In this guide, we will show you how to install an E-Lift charging station easily and quickly. See everything you need below.
Guide E-Lift
Installer supplies:
- USB to USB-C cable
Follow the steps:
(When removing the SIM card according to figure B) Connect the USB to USB-C cable to the charging controller on the USB port:
Note: always download the RNDIS driver for your computer. The driver can be found at "catalog.update.microsoft.com"
Look for the USB / RNDIS if the USB is connected to the USB-C on the charging controller:
- Zoek naar de USB / RNDIS als de USB is aangesloten op de USB-C op de laadcontroller:
- Set the IP address:
- In the internet browser, go to IP address: 192.168.5.1 to connect to the load controller
- Log in to the controller: (top right)
- You can log in with the following users:
- Gehen Sie dann zu den OCPP-Einstellungen, um die E-flux-Verbindung einzurichten
- Enter the backend URL and the ID of E-Flux, the network Interface for a GSM connection should be set to Cellular Network.
- Get the modem settings right
- Install the latest firmware, find the current version here:
-Install software: https://www.phoenixcontact.com/nl-nl/
Example of a update:
- Reboot the charging controller after all settings and steps have been performed
- When the controller is online after the reboot, the LINK LED on the front will be permanently on, APP will flash red while connecting to E-flux until it is fully online.