Guide for Blitzpower
In this guide, we will show you how to install an Blitzpower charging station easily and quickly. See everything you need below.
Guide Blitzpower
Configuration of the OCPP Provider
- Step 1. Make sure to have a local connection with the charging station via UTP
- Go to http://ev3000.local:3000
Step 2.
- Log in using the following data: Username: operator Password: blitzoperator91500591
Step 3.
- Click on “Quick setup”
Step 4.
- Connect the station to the Internet (see image below)
You can do this one of the two ways: UTP:
I) Click on “DHCP”; II) The IP address and the subnet mask will fill be filled in automatically; II) Enter the Gateway. You do this by copying your IP address and replacing the last number of it with a 1. For example: If your IP address is 192.168.2.36, delete “36” and write “1” instead. Your Gateway should then be - 192.168.2.1
OR
Sim-card: Enter SIM card details:
I) Sim Pin – leave this field empty; II) APN – enter – m2m.services; III) Save the changes.
Step 5.
- Indicate which charge points do you want to connect to the OCPP or click on “Configure All”
Step 6.
- Choose E-Flux as the OCPP provider
Step 7.
- Click “Save”